Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASDRIVER ASSISTANCE SYSTEMECU DIAGNOSIS INFORMATIONSIDE RADAR RHDTC INDEX
2024 Nissan-Datsun Frontier SL, RWD
DTC Index
2024 Nissan-Datsun Frontier SL, RWDSECTION DTC Index
x: Applicable
| DTC | Fail-safe | Reference | |
|---|---|---|---|
| Blind Spot Warning/Rear Cross Traffic Alert | |||
| C1B30-49 | Side radar LH malfunction | x | DTC Description |
| C1B50-49 | SIDE RDR MALFUNCTION | x | DTC Description |
| C1B51-16 | BSW/BSI IND SHORT CIR | x | DTC Description |
| C1B52-17 | BSW/BSI IND OPEN CIR | x | DTC Description |
| C1B55-97 | RADAR BLOCKAGE | x | DTC Description |
| C1E82-82 | STRG SEN CAN CIR1 | x | DTC Description |
| C1E82-86 | STRG SEN CAN CIR1 | x | DTC Description |
| U0104-82 | ADAS CAN CIR1 | x | DTC Description |
| U0405-83 | ADAS CAN CIR2 | x | DTC Description |
| U0415-00 | VDC CAN CIR1 | x | DTC Description |
| U1000-01 | CAN COMM CIRCUIT | x | DTC Description |
| U1010-49 | CONTROL UNIT (CAN) | x | DTC Description |
| U2156-83 | STRG SEN CAN CIR2 | x | DTC Description |
| U216C-82 | ADAS CAN circuit | x | DTC Description |
| U216C-83 | ADAS CAN circuit | x | DTC Description |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.