Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSSECURITY CONTROL SYSTEMBASIC INSPECTIONADDITIONAL SERVICE WHEN REPLACING CONTROL UNITECMWORK PROCEDURE

2024 Nissan-Datsun Frontier SL, RWD

Work Procedure

2024 Nissan-Datsun Frontier SL, RWDSECTION Work Procedure

PERFORM ECM RECOMMUNICATING FUNCTION
1. 1. Install ECM.
  2. Contact back side of registered Intelligent Key * to ignition switch, then place ignition switch ON.
    *: To perform this step, use the key that is used before performing ECM replacement.
  3. Maintain ignition switch in the ON position for at least 5 seconds.
  4. Ignition switch OFF.
  5. Check that the engine starts.
>>

GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
1. Perform Work Procedure .
>>

End.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.