SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESBRAKE CONTROL SYSTEM (VDC/TCS/ABS)SYMPTOM DIAGNOSISDOES NOT OPERATEDIAGNOSIS PROCEDURE
2015 Nissan-Datsun Rogue SV, AWD

Diagnosis Procedure

2015 Nissan-Datsun Rogue SV, AWDSECTION Diagnosis Procedure
CAUTION:
  • VDC function, TCS function, ABS function, EBD function, Brake limited slip differential (BLSD) function, Brake assist function, hill start assist function and Brake force distribution function never operate when the vehicle speed is 10 km/h (6.2 MPH) or less. However, TCS function, Brake limited slip differential (BLSD) function and hill start assist function operates when the vehicle speed is 0 km/h (0 MPH) (the vehicle is in stop status).
  • VDC function and TCS function never operate when VDC OFF switch is operated (when VDC OFF indicator lamp turns ON).

  1. CHECK ABS WARNING LAMP

    Check that ABS warning lamp, brake warning lamp and VDC warning lamp turn ON and turn OFF approx. 1 second after key switch is turned ON. Check that ABS warning lamp, brake warning lamp and VDC warning lamp and stay in OFF status during driving.

    CAUTION:

    Brake warning lamp turns ON when parking brake is operated (parking brake switch is ON) or brake fluid is less than the specified level (brake fluid level switch is ON).

    Is the inspection result normal?

    YES 

    Normal

    NO 

    GO TO STEP 2  .

  2. PERFORM SELF DIAGNOSTIC

    CONON With CONSULT

    1. Turn the ignition switch OFF → ON.
      CAUTION:
      • Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
      • Start the engine.
    2. Repeat step 1 two or more times.
    3. Perform "Self Diagnostic Result" of "ABS" with CONSULT.

    Is any DTC detected?

    YES 

    Check the DTC. Refer to DTC INDEX .

    NO 

    Inspection End.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.