SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2015ROGUE SV, AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROL SYSTEM (VDC/TCS/ABS)ECU DIAGNOSIS INFORMATIONABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)DTC INDEX
2015 Nissan-Datsun Rogue SV, AWD

DTC Index

2015 Nissan-Datsun Rogue SV, AWDSECTION DTC Index
DTC Display Item VDC warning lamp ABS warning lamp Brake warning lamp Refer to
C1101 RR RH SENSOR-1 ON ON OFF DTC LOGIC 
C1102 RR LH SENSOR-1 ON ON OFF
C1103 FR RH SENSOR-1 ON ON OFF
C1104 FR LH SENSOR-1 ON ON OFF
C1105 RR RH SENSOR-2 ON ON OFF DTC LOGIC 
C1106 RR LH SENSOR-2 ON ON OFF
C1107 FR RH SENSOR-2 ON ON OFF
C1108 FR LH SENSOR-2 ON ON OFF
C1109 BATTERY VOLTAGE [ABNOMAL] ON ON ON DTC LOGIC 
C1111 PUMP MOTOR ON ON ON DTC LOGIC 
C1113 G SENSOR ON ON OFF DTC LOGIC 
C1115 ABS SENSOR [ABNORMAL SIGNAL] ON ON OFF DTC LOGIC 
C1120 FR LH IN ABS SOL ON ON ON DTC LOGIC 
C1121 FR LH OUT ABS SOL ON ON ON DTC LOGIC 
C1122 FR RH IN ABS SOL ON ON ON DTC LOGIC 
C1123 FR RH OUT ABS SOL ON ON ON DTC LOGIC 
C1124 RR LH IN ABS SOL ON ON ON DTC LOGIC 
C1125 RR LH OUT ABS SOL ON ON ON DTC LOGIC 
C1126 RR RH IN ABS SOL ON ON ON DTC LOGIC 
C1127 RR RH OUT ABS SOL ON ON ON DTC LOGIC 
C1130 ENGINE SIGNAL 1 ON OFF OFF DTC LOGIC 
C1140 ACTUATOR RLY ON ON ON DTC LOGIC 
C1142 PRESS SEN CIRCUIT ON OFF OFF DTC LOGIC 
C1143 ST ANG SEN CIRCUIT ON OFF OFF DTC LOGIC 
C1144 ST ANG SEN SIGNAL ON OFF OFF DTC LOGIC 
C1145 YAW RATE SENSOR ON ON OFF DTC LOGIC 
C1146 SIDE G SEN CIRCUIT ON ON OFF
C1155 BR FLUID LEVEL LOW ON OFF OFF DTC LOGIC 
C1160 DECEL G SEN SET ON ON OFF DTC LOGIC 
C1164 CV 1 ON ON ON DTC LOGIC 
C1165 CV 2 ON ON ON
C1170 VARIANT CODING ON ON OFF DTC LOGIC 
C1197 VACUUM SENSOR OFF OFF ON DTC LOGIC 
C1198 VACUUM SEN CIR OFF OFF ON DTC LOGIC 
C1199 BRAKE BOOSTER OFF OFF ON DTC LOGIC 
C119A VACUUM SEN VOLT OFF OFF ON DTC LOGIC 
U1000 CAN COMM CIRCUIT ON OFF OFF DTC LOGIC 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.