SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2014NV3500 HD S, VAN CARGOREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (INTRODUCTION) (VK56DE)BASIC INSPECTIONHOW TO ERASE PERMANENT DTCWORK PROCEDURE (GROUP A)
2014 Nissan-Datsun NV3500 HD S, Van Cargo

Work Procedure (Group A)

2014 Nissan-Datsun NV3500 HD S, Van CargoSECTION Work Procedure (Group A)
Fig 1: Driving Pattern For Erasing Permanent DTC Work Procedure (Group A)
G09442651Courtesy of NISSAN NORTH AMERICA, INC.
  1. CHECK DTC 

    Check DTC.

    Is any DTC detected? 

    YES: Repair malfunction(s) and erase DTC. Refer to "ON BOARD DIAGNOSIS FUNCTION " or "CONSULT FUNCTION ".

    NO: GO TO 2.

  2. CHECK PERMANENT DTC 

    With CONSULT

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select "PERMANENT DTC STATUS" mode with CONSULT.

    With GST

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select Service $0A with GST.

      Is any permanent DTC detected? 

      YES: GO TO 3.

      NO: END

  3. PERFORM DTC CONFIRMATION PROCEDURE 

    Perform "DTC CONFIRMATION PROCEDURE" for DTCs which are the same as permanent DTCs stored in ECM. Refer to "DTC INDEX ".

    :GO TO 4.

  4. CHECK PERMANENT DTC 

    With CONSULT

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select "PERMANENT DTC STATUS" mode with CONSULT.

    With GST

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select Service $0A with GST.

      Is any permanent DTC detected? 

      YES: GO TO  1.

      NO: END

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.