Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2014NV3500 HD S, VAN CARGOREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (INTRODUCTION) (VK56DE)
2014 Nissan-Datsun NV3500 HD S, Van Cargo
Engine Control System (Introduction) (VK56DE)
2014 Nissan-Datsun NV3500 HD S, Van CargoSECTION Engine Control System (Introduction) (VK56DE)
- Precaution
- Preparation
- System Description
- Component Parts
- Engine Control System
- ENGINE CONTROL SYSTEM: Component Parts Location
- ECM
- Malfunction Indicator lamp (MIL)
- Accelerator Pedal Position Sensor
- Electric Throttle Control Actuator
- Ignition Coil (With Power Transistor)
- Fuel Injector
- Mass Air Flow Sensor (With Intake Air Temperature Sensor)
- Camshaft Position Sensor (PHASE)
- Crankshaft Position Sensor (POS)
- Intake Valve Timing Control Solenoid Valve
- Engine Coolant Temperature Sensor
- Knock Sensor
- Refrigerant Pressure Sensor
- Power Steering Pressure Sensor
- Cooling Fan
- EVAP Canister
- EVAP Canister Purge Volume Control Solenoid Valve
- EVAP Canister Vent Control Valve
- EVAP Control System Pressure Sensor
- Air Fuel Ratio (A/F) Sensor 1
- Heated Oxygen Sensor 2
- Fuel Level Sensor Unit and Fuel Pump
- Fuel Tank Temperature Sensor
- ASCD Steering Switch
- Stop Lamp Switch & ASCD Brake Switch
- Engine Control System
- Structure And Operation
- System
- Operation
- On Board Diagnostic (OBD) System
- Diagnosis System (ECM)
- Diagnosis Description
- DIAGNOSIS DESCRIPTION: 1st Trip Detection Logic and Two Trip Detection Logic
- DIAGNOSIS DESCRIPTION: DTC and Freeze Frame Data
- DIAGNOSIS DESCRIPTION: Counter System
- DIAGNOSIS DESCRIPTION: Driving Pattern
- DIAGNOSIS DESCRIPTION: System Readiness Test (SRT) Code
- DIAGNOSIS DESCRIPTION: Permanent Diagnostic Trouble Code (Permanent DTC)
- DIAGNOSIS DESCRIPTION: Malfunction Indicator Lamp (MIL)
- On Board Diagnosis Function
- CONSULT Function
- Diagnosis Description
- Component Parts
- Ecu Diagnosis Information
- Wiring Diagram
- Basic Inspection
- Diagnosis And Repair Workflow
- Basic Inspection
- Additional Service When Replacing ECM
- Accelerator Pedal Released Position Learning
- Throttle Valve Closed Position Learning
- Idle Air Volume Learning
- Mixture Ratio Self-Learning Value Clear
- VIN Registration
- Fuel Pressure
- How To Set SRT Code
- How To Erase Permanent DTC
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.