SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE SL, 4WDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSMISSIONECU DIAGNOSIS INFORMATIONTCMDTC INDEX
2013 Nissan-Datsun Juke SL, 4WD

DTC Index

2013 Nissan-Datsun Juke SL, 4WDSECTION DTC Index
NOTE: If multiple malfunction codes are detected at the same time, check each code according to the "DTC check priority list". "DTC INSPECTION PRIORITY CHART ".
DTC Items (CONSULT screen terms) Reference
"ENGINE" with CONSULT or GST(1) "TRANSMISSION" with CONSULT
- P0703  BRAKE SWITCH B  
P0705  P0705 T/M RANGE SENSOR A  
P0710  P0710 FLUID TEMP SENSOR A  
P0715  P0715 INPUT SPEED SENSOR A  
P0720  P0720 OUTPUT SPEED SENSOR  
- P0725  ENGINE SPEED  
P0740  P0740 TORQUE CONVERTER  
P0744  P0744 TORQUE CONVERTER  
P0745  P0745 PC SOLENOID A  
P0746  P0746 PC SOLENOID A  
P0776  P0776 PC SOLENOID B  
P0778  P0778 PC SOLENOID B  
- P0826  UP/DOWN SHIFT SWITCH  
P0840  P0840 FLUID PRESS SEN/SW A  
- P0841  FLUID PRESS SEN/SW A  
- P0868  FLUID PRESS LOW  
- P1701  TCM  
- P1705  TP SENSOR  
- P1709  INCOMPLETED DATA WRITING  
- P1722  VEHICLE SPEED  
- P1723  SPEED SENSOR  
- P1726  THROTTLE CONTROL SIG  
P1740  P1740 SLCT SOLENOID  
P1777  P1777 STEP MOTOR  
P1778  P1778 STEP MOTOR  
U0100  U0100 LOST COMM (ECM A)  
U1000  U1000 CAN COMM CIRCUIT  
- U1010  CONTROL UNIT (CAN)  
(1) These numbers are prescribed by SAE J2012.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.