SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE SL, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR BODY PANELSDOOR & LOCK (WITHOUT INTELLIGENT KEY SYSTEM)SYMPTOM DIAGNOSISP RANGE INTERLOCK DOOR LOCK/UNLOCK FUNCTION DOES NOT OPERATEDIAGNOSIS PROCEDURE
2013 Nissan-Datsun Juke SL, 4WD

Diagnosis Procedure

2013 Nissan-Datsun Juke SL, 4WDSECTION Diagnosis Procedure
  1. CHECK "AUTOMATIC LOCK/UNLOCK SELECT" SETTING IN "WORK SUPPORT" 
    1. Select "DOOR LOCK" of "BCM" using CONSULT.
    2. Select "AUTOMATIC LOCK/UNLOCK SELECT" in "WORK SUPPORT" mode.
    3. Check "AUTOMATIC LOCK/UNLOCK SELECT" setting in "WORK SUPPORT".

      Refer to "DOOR LOCK: CONSULT FUNCTION (BCM - DOOR LOCK) ".

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Set "Unlock Only", "Lock Only" or "Lock/Unlock" in "AUTOMATIC LOCK/UNLOCK SELECT".

  2. CHECK "AUTOMATIC DOOR LOCK SELECT" SETTING IN "WORK SUPPORT" 
    1. Select "DOOR LOCK" of "BCM" using CONSULT.
    2. Select "AUTOMATIC DOOR LOCK SELECT" in "WORK SUPPORT" mode.
    3. Check "AUTOMATIC DOOR LOCK SELECT" setting in "WORK SUPPORT".

      Refer to "DOOR LOCK: CONSULT FUNCTION (BCM - DOOR LOCK) ".

      Is the inspection result normal? 

      YES: GO TO 3.

      NO: Set "P RANGE" in "AUTOMATIC DOOR LOCK SELECT".

  3. CHECK "AUTOMATIC DOOR UNLOCK SELECT" SETTING IN "WORK SUPPORT" 
    1. Select "DOOR LOCK" of "BCM" using CONSULT.
    2. Select "AUTOMATIC DOOR UNLOCK SELECT" in "WORK SUPPORT" mode.
    3. Check "AUTOMATIC DOOR UNLOCK SELECT" setting in "WORK SUPPORT".

      Refer to "DOOR LOCK: CONSULT FUNCTION (BCM - DOOR LOCK) ".

      Is the inspection result normal? 

      YES: GO TO 4.

      NO: Set "MODE 2" or "MODE 4" in "AUTOMATIC DOOR UNLOCK SELECT".

  4. CHECK TCM 

    Check TCM for DTC.

    Refer to "DTC INDEX ".

    Is the inspection result normal? 

    YES: GO TO 5.

    NO: Repair or replace the malfunctioning parts.

  5. REPLACE BCM 
    1. Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
    2. Confirm the operation after replacement.

      Is the result normal? 

      YES: INSPECTION END

      NO: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.