Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013370Z BASE, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM - COMPONENT TESTINGS-MODE SWITCHCOMPONENT INSPECTION
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard Trans
Component Inspection
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard TransSECTION Component Inspection
- CHECK S-MODE SWITCH
- Turn ignition switch OFF.
- Disconnect S-MODE switch harness connector.
- Check the continuity between S-MODE switch terminals under the following conditions.
Terminals Condition Continuity 1 and 2 S-MODE switch Pressed Existed Released Not Existed Is the inspection result normal?
YES: INSPECTION END
NO: Replace S-MODE switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.