Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013370Z BASE, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM - COMPONENT TESTING
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard Trans
Engine Control System - Component Testing
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard TransSECTION Engine Control System - Component Testing
- ASCD Brake Switch
- ASCD Indicator
- Cooling Fan
- Electrical Load Signal
- Fuel Injector
- Fuel Pump
- Ignition Signal
- Malfunction Indicator Lamp
- On Board Refueling Vapor Recovery (ORVR)
- Positive Crankcase Ventilation
- Refrigerant Pressure Sensor
- Shift Position Indicator
- S-Mode Switch
- Ecu Diagnosis Information
- Symptom Diagnosis
- Precaution
- Precautions
- Except For MEXICO
- EXCEPT FOR MEXICO: Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- EXCEPT FOR MEXICO: Precaution for Battery Service
- EXCEPT FOR MEXICO: Precaution for Procedure without Cowl Top Cover
- EXCEPT FOR MEXICO: Precautions For Xenon Headlamp Service
- EXCEPT FOR MEXICO: On Board Diagnostic (OBD) System of Engine and A/T
- EXCEPT FOR MEXICO: General Precautions
- For MEXICO
- FOR MEXICO: Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- FOR MEXICO: Precaution for Battery Service
- FOR MEXICO: Precaution for Procedure without Cowl Top Cover
- FOR MEXICO: Precautions For Xenon Headlamp Service
- FOR MEXICO: On Board Diagnostic (OBD) System of Engine and A/T
- FOR MEXICO: General Precautions
- Except For MEXICO
- Precautions
- Preparation
- Periodic Maintenance
- Service Data And Specifications (SDS)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.