Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013370Z BASE, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (INTRODUCTION)BASIC INSPECTIONINSPECTION AND ADJUSTMENTVVEL CONTROL SHAFT POSITION SENSOR ADJUSTMENTVVEL CONTROL SHAFT POSITION SENSOR ADJUSTMENT: DESCRIPTION
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard Trans
VVEL CONTROL SHAFT POSITION SENSOR ADJUSTMENT: Description
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard TransSECTION VVEL CONTROL SHAFT POSITION SENSOR ADJUSTMENT: Description
VVEL control shaft position sensor adjustment is an operation to adjust the initial position angle that is the basis for the VVEL control shaft position sensor.
It must be performed each time VVEL actuator sub assembly is replaced.
CAUTION:
- It must be performed only on the replaced bank side.
- It must not be performed except when VVEL actuator sub assembly is replaced. If by any chance the adjustment is performed, replace VVEL actuator sub assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.