Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013370Z BASE, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (INTRODUCTION)BASIC INSPECTIONINSPECTION AND ADJUSTMENTMIXTURE RATIO SELF-LEARNING VALUE CLEARMIXTURE RATIO SELF-LEARNING VALUE CLEAR: SPECIAL REPAIR REQUIREMENT
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard Trans
MIXTURE RATIO SELF-LEARNING VALUE CLEAR: Special Repair Requirement
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard TransSECTION MIXTURE RATIO SELF-LEARNING VALUE CLEAR: Special Repair Requirement
- START
With CONSULT
- Start engine and warm it up to normal operating temperature.
- Select "SELF-LEARNING CONT" in "WORK SUPPORT" mode with CONSULT.
- Clear mixture ratio self-learning value by touching "CLEAR".
With GST
- Start engine and warm it up to normal operating temperature.
- Turn ignition switch OFF.
- Disconnect mass air flow sensor (bank 1) harness connector.
- Restart engine and let it idle for at least 5 seconds.
- Stop engine and reconnect mass air flow sensor (bank 1) harness connector.
- Select Service $03 with GST. Make sure DTC P0102 is detected.
- Select Service $04 with GST to erase the DTC P0102.
: END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.