Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Section 2053 (Driver Information System)
WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Precaution
- Preparation
- Combination Meters
- Component Parts and Harness Connector Location
- System Description
- Arrangement of Combination Meter
- Internal Circuit
- Wiring Diagram - METER
- Combination Meter Harness Connector Terminal Layout
- Terminals and Reference Value for Combination Meter
- Self-Diagnosis Mode of Combination Meter
- CONSULT-II Function (METER)
- Trouble Diagnosis
- Symptom Chart
- Power Supply and Ground Circuit Inspection
- Vehicle Speed Signal Inspection
- Water Temperature Signal Inspection
- Engine Speed Signal Inspection
- Fuel Level Sensor Unit Inspection
- Fuel Gauge Fluctuates, Indicates Wrong Value, or Varies
- Fuel Gauge Does Not Move to Full-position
- DTC [U1000] CAN Communication Circuit
- DTC [B2205] Vehicle Speed Circuit
- Electrical Components Inspection
- Combination Meter
- Warning Lamps
- A/T Indicator
- Warning Chime
- Component Parts and Harness Connector Location
- System Description
- CAN Communication System Description
- Wiring Diagram - CHIME
- Terminals and Reference Value for BCM
- Combination Meter Harness Connector Terminal Layout
- Terminals and Reference Value for Combination Meter
- How to Proceed With Trouble Diagnosis
- Preliminary Check
- CONSULT-II Function (BCM)
- All Warning Chimes Do Not Operate
- Key Warning Chime and Light Warning Chime Do Not Operate (Seat Belt Warning Chime Does Operate)
- Key Warning Chime Does Not Operate
- Light Warning Chime Does Not Operate
- Seat Belt Warning Chime Does Not Operate
- Rear Sonar System
- Component Parts and Harness Connector Location
- System Description
- Wiring Diagram - SONAR
- Sonar Control Unit Harness Connector Terminal Layout
- Terminals And Reference Value For Sonar Control Unit
- How to Proceed With Trouble Diagnosis
- Pre-diagnosis Inspection
- Self-diagnosis Function
- Preliminary Check
- Symptom Chart
- Component Inspection
- Rear Sonar Sensors
- Sonar Control Unit
- Rear View Monitor
- Component Parts and Harness Connector Location
- System Description
- Schematic
- Wiring Diagram - R/VIEW
- Rear View Camera Control Unit Harness Connector Terminal Layout
- Terminals and Reference Value for Rear View Camera Control Unit
- CONSULT-II Function (REARVIEW CAMERA)
- Side Distance Guideline Correction
- Power Supply and Ground Circuit Inspection
- Rear View Is Not Displayed With The A/T Selector Lever In R Position
- Rear View Camera Control Unit
- Rear View Camera
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.