Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
System Description: Function
WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
Power is supplied at all times
- through 50A fuse (letter j, located in the fuse and fusible link box)
- to BCM terminal 70, and
- through 15A fuse [No. 19, located in the fuse block (J/B)]
- to key switch terminal 1.
With ignition switch in ON or START position, power is supplied
- through 10A fuse [No. 16, located in the fuse block (J/B)]
- to BCM terminal 38.
Ground is supplied
- to BCM terminal 67
- through body grounds M57, M61, and M79.
NOTE:
When ignition key warning chime, light warning chime, and seat belt warning chime are required at the same time, the priorities for each chime are the following.
- Light warning chime
- Ignition key warning chime
- Seat belt warning chime
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.