WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Speedometer, odometer, tachometer, fuel gauge and water temperature gauge are controlled by the combination meter.
Warning indicators are controlled by signals drawn from the CAN communication system and components connected directly to the combination meter.
Digital meter is adopted for odometer.
NOTE: The record of the odometer is kept even if the battery cable is disconnected. The record of the trip meter is erased when the battery is disconnected.
Odometer/trip meter and A/T indicator segments can be checked in self-diagnosis mode.
Meters/gauges can be checked in self-diagnosis mode.
All warning indicators except air bag, washer fluid, security and seat belt can be checked in self-diagnosis mode.

NOTE: Under the following conditions, the meters will perform a homing function. The meter pointers will move down slightly and then move back to the resting position. This is a normal design condition.

Approximately 60 seconds after turning the ignition switch from the ON to the OFF position
If the battery is disconnected and then reconnected

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Unified Meter Control Unit: Notes

Use the Manual With the Right Hardware

When to See a Mechanic