Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007OUTLANDER LS, FWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLACTIVE STABILITY CONTROL SYSTEM (ASC)HYDRAULIC UNITREMOVAL AND INSTALLATIONINSTALLATION SERVICE POINTSA << BRAKE TUBE CONNECTION
2007 Mitsubishi Outlander LS, FWD
A << Brake Tube Connection
2007 Mitsubishi Outlander LS, FWDSECTION A << Brake Tube Connection
Install the brake pipe to the hydraulic unit as shown in the figure.
- To rear brake (RH) < Marking color: White >
- From master cylinder (secondary) < Marking color: Yellow and white >
- To front brake (LH) < Marking color: Red and white >
- To front brake (RH) < Marking color: Orange and white >
- From master cylinder (primary) < Marking color: Blue and white >
- To rear brake (LH) < Marking color: Pink >
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.