Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Resistance And Continuity Between Harness-Side Connector Terminals
2007 Mitsubishi Outlander LS, FWDSECTION Resistance And Continuity Between Harness-Side Connector Terminals
Required Special Tool:
MB991997: ASC Check Harness
- When performing the continuity check, turn the ignition switch to LOCK (OFF) position, connect special tool MB991997 as shown in the figure, and disconnect the ASC-ECU connector.
- Check for continuity between terminals shown in the chart below.
- Terminal layout is shown in the figure.
TERMINAL NUMBER REFERENCE
| Terminal No. | Signal | Normal conditions |
|---|---|---|
| 16 - body ground | Ground | 2 ohms or less |
| 47 - body ground | Ground | 2 ohms or less |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.