Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007OUTLANDER LS, FWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLACTIVE STABILITY CONTROL SYSTEM (ASC)ASC OFF SWITCHINSPECTIONASC OFF SWITCH CONTINUITY CHECK
2007 Mitsubishi Outlander LS, FWD
ASC Off Switch Continuity Check
2007 Mitsubishi Outlander LS, FWDSECTION ASC Off Switch Continuity Check
- As shown in the figure, connect the circuit tester to the ASC OFF switch terminals No. 1 and No. 2 as a single unit.
- If continuity is detected when the ASC OFF switch is pressed and if not detected when the switch is released, the ASC OFF switch is in good condition.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.