Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI1990PRECIS BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONFRONT SUSPENSIONSUSPENSION - FRONTREMOVAL & INSTALLATIONLOWER CONTROL ARM BUSHINGS (MIRAGE 1.5L)INSTALLATION
1990 Mitsubishi Precis Base, Standard
Lower Control Arm Bushings (Mirage 1.5L): Installation
1990 Mitsubishi Precis Base, StandardSECTION Installation
- Apply soapy water on the control arm shaft and replacement bushing. Install bushing on control arm shaft, with locator pin located within 72-78 degrees of control arm's center.
- Using press and wood block, press bushing on control arm until specified clearance exists between bushing and control arm. See BUSHING CLEARANCE SPECIFICATIONS table. See Fig 1 .
BUSHING CLEARANCE SPECIFICATIONS
| Application | In. (mm) |
|---|---|
| Mirage 1.5L | .04-.12 (1-3) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.