61 31 195 Removing And Installing (Replacing) Front Controller

2013 Mini Cooper S Paceman, Automatic TransSECTION 61 31 195 Removing And Installing (Replacing) Front Controller
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760Li, 2005 BMW 760Li, and 2004 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Operation is described in: Remove and install decorative strip on center armrest. Refer to 51 16 197 REMOVING AND INSTALLING/REPLACING DECORATIVE TRIM ON CENTRE ARMREST .

Replacement:Β 

Carry out coding/programming.

Observe following IDC specifications:

  • Programming.
  • Coding.
  • Car & Key Memory.
  • CD "CIP".
    Fig 1: DIS Programming Unit
    G03293868Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.