Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Normal Operation
When the speed control actuator carries out the self-test, it checks for continuity to ground through circuit 199 (LB/YE). This is accomplished by sending a voltage reference signal to the clutch pedal position (CPP) switch (manual transaxle) or the transmission range (TR) sensor (automatic transaxle).
When the clutch is applied, the signal is routed through circuit 359 (GY/RD) to the powertrain control module (PCM). The PCM provides an internal ground.
When the automatic transaxle is in NEUTRAL, the signal is routed through circuit 57 (BK) to ground.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.