Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2009MILAN PREMIER, 3.0 1, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1006 (SEATING)REMOVAL AND INSTALLATIONDUAL CLIMATE CONTROLLED SEAT MODULE (DCSM)INSTALLATION
2009 Mercury Milan Premier, 3.0 1, AWD
Dual Climate Controlled Seat Module (DCSM): Installation
2009 Mercury Milan Premier, 3.0 1, AWDSECTION Installation
WARNING: This page is about a different car, the 2008 Mercury Milan, 2008 Lincoln MKZ, and 2008 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Install the DCSM to the seat.
- Position the DCSM to the electrical bracket and install 2 new rivets.
- Connect the 3 DCSM electrical connectors and locking wedges.
- Install the front seat and repower the SRS. Do not prove out the SRS at this time. For additional information, refer to Seat - Front .
- Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test. For additional information, refer to the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM article.
- After installing the DCSM, carry out the appropriate steps in the PMI procedure. For additional information, refer to MODULE CONFIGURATION article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.