Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCEDES BENZ2021GT 53 AMGREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSELECTRICAL SYSTEM -- ENGINE -- 290 CHASSIS
2021 Mercedes Benz GT 53 AMG
Electrical System -- Engine -- 290 Chassis
2021 Mercedes Benz GT 53 AMGSECTION Electrical System -- Engine -- 290 Chassis
- General Information
- Basic Knowledge
- Testing & Repair
- Remove/Install Ignition Coils
- Remove/Install Crankshaft Hall Sensor
- Remove/Install Camshaft Sensor
- Remove/Install Knock Sensor
- Remove/Install Left Front Knock Sensor - AR15.12-P-2186MNI
- Remove/Install Left Front Knock Sensor - AR15.12-P-2186MSA
- Remove/Install Left Rear Knock Sensor - AR15.12-P-2187MNI
- Remove/Install Left Rear Knock Sensor - AR15.12-P-2187MSA
- Remove/Install Right Front Knock Sensor - AR15.12-P-2188MNI
- Remove/Install Right Rear Knock Sensor - AR15.12-P-2189MNI
- Remove/Install Fuel Injection System Engine Wiring Harness - AR15.18-P-0003MSA
- Remove/Install Crankcase Engine Wiring Harness - AR15.18-P-0006MSA
- Remove/Install Cylinder Head Engine Wiring Harness - AR15.18-P-0007MSA
- Disconnect/Connect Engine Wiring Harness To Remove Engine
- Remove/Install Starter - AR15.30-P-7100MNI
- Tightening Procedure Of Integrated Starter Alternator - AR15.40-P-0003-01MRT
- Determine Gap Between Stator And Rotor - AR15.40-P-0003-03MRT
- Perform Resistance Measurement Of Coils Of Integrated Starter Alternator - AR15.40-P-0003-04MRT
- Detach/Attach Tool For Installation/Removal Of Integrated Starter Alternator - AR15.40-P-0003-05MRT
- Remove/Install Integrated Starter Alternator - AR15.40-P-0003MSA
- Remove/Install Integrated Starter Alternator Control Unit - AR15.40-P-0004MSA
- Check Alternator - AR15.40-P-5001MNI
- Remove/Install Alternator - AR15.40-P-5032MNI
- Remove/Install Coolant Temperature Sensor
- Test & Adjustment Values
- Maintenance
- Torque Specifications
- Tightening Torques: Passenger Cars: Electrical System - Engine - BA15.00-Z-9999AZ
- Ignition System
- Knock Sensors
- Position Sensor
- Ignition Coil
- Ground Strap - BA15.10-P-1000-05F
- Engine Wiring Harness
- 48 V On-Board Electrical System Subharness - BA15.18-P-1000-03MRT
- Starter
- Generator - BA15.40-P-1000-01T
- Integrated Starter Alternator
- Temperature Sensor - BA15.60-P-1000-02MRT
- Forms
- Wiring Diagrams
- Special Tools
- 124 589 09 63 00 Ohm Decade - WS15.00-N-0009C
- 201 589 00 99 00 Electrical Connection Kit - WS15.00-N-0014C
- 124 589 09 63 00 Ohm Decade - WS15.00-P-0009C
- 602 589 00 10 00 Socket Wrench - WS15.00-P-0015B
- 177 589 00 63 00 Adapter Cable, 5-Pin - WS15.00-P-0023B
- 177 589 01 63 00 Adapter Cable, 4-Pin - WS15.00-P-0025B
- 281 589 01 63 00 Adapter Cable - WS15.00-P-0026B
- 000 588 03 19 00 Load Tester - WS15.00-P-0027B
- 256 589 01 31 00 Support Fixture - WS15.00-P-0029B
- 256 589 01 23 00 Gauge - WS15.00-P-0047B
- 278 589 00 09 00 Spark Plug Wrench - WS15.00-P-0065B
- 256 586 00 09 00 Socket Wrench Socket - WS15.00-P-0070A
- 000 588 31 19 00 Load Tester - WS15.00-P-0077B
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.