Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE
Check & Adjust Front Toe Angle: Adjustments
For check and adjustment procedure refer to illustrations. See Fig 1 -Fig 3 .
- Swing the sun visor to the side, fix the steering wheel in the center position and install the holding device (055). See Fig 1 . Also, see Figure under SPECIAL TOOLS.
- Check center position of steering gear and steering wheel. The steering gear is in the center position when the marking on the cap matches the marking on the control valve housing (arrow). See Fig 2 .
- If markings line up, but steering wheel is off center, if necessary, remove steering wheel and move by a maximum of one tooth on steering shaft. If necessary disable AIRBAG:
- For 2003 models. See DISABLING & ACTIVATING AIR BAG SYSTEM under MERCEDES-BENZ in AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION.
- For 2004 models. See DISABLING & ACTIVATING AIR BAG SYSTEM in AIR BAG DEACTIVATION PROCEDURES - MERCEDES-BENZ article in GENERAL INFORMATION.
- Make adjustments to toe angle if necessary. See WHEEL ALIGNMENT SPECIFICATIONSΒ .
- Adjust toe-in, loosen the lock nut (10f) and twist the tie rod (10). See Fig 3 .
- Check boot on tie rod is not twisted after adjusting toe-angle.
- Tighten locking nut for tie rod on inner tie rod. See TORQUE SPECIFICATIONSΒ .
- Recheck all alignment specifications, See PERFORMING CHASSIS ALIGNMENT CHECKΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
