Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Mercedes Benz ML430FACTORY OEM SERVICE PROCEDURE
Performing Chassis Alignment Check
- Drive vehicle onto electronic alignment system. Unlock rotary and sliding plates. Install brake pedal winch on brake pedal. Attach measuring heads to each wheel. Perform initial measurements.
- Check vehicle level at front and rear axle and adjust as necessary. See RIDING HEIGHT ADJUSTMENTS .
- Perform alignment procedure as follows:
- Check and adjust toe-in at rear axle. See CHECK & ADJUST REAR TOE ANGLE .
- Check camber and caster at rear axle. See CHECK & ADJUST CAMBER & CASTER AT REAR AXLE .
- Check camber and caster at front axle. See CHECK & ADJUST CAMBER & CASTER AT FRONT AXLE .
- Check and adjust toe-in at front axle. See CHECK & ADJUST FRONT TOE ANGLE .
- Recheck alignment measurement.
- Remove alignment equipment from vehicle. Test drive vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.