Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2010CX-9 SPORT, 3.7 V, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSON-BOARD DIAGNOSTIC [AUDIO]
2010 Mazda CX-9 Sport, 3.7 V, AWD
On-Board Diagnostic [Audio]
2010 Mazda CX-9 Sport, 3.7 V, AWDSECTION On-Board Diagnostic [Audio]
- Foreword [Audio]
- DTC Inspection [Audio]
- Supplier Identification Procedure [Audio]
- Clearing DTC [Audio]
- DTC Table [Audio]
- DTC: B1188:64, 10:Er07, 22:Er07, DEVICE CORD 22/ERROR CORD 07 [AUDIO]
- DTC: B1A89:13 [Audio]
- DTC: B1D19:71, 10:ER02, 22:Er02, DEVICE CORD 22/ERROR CORD 02 [AUDIO]
- DTC: B1D19:79, 10:Er01, 22:Er01, DEVICE CORD 22/ERROR CORD 01 [AUDIO]
- DTC: B1D19:96, 10:Er10, 22:Er10, DEVICE CORD 22/ERROR CORD 10 [AUDIO]
- DTC: U3000:09, 09:Er21, DEVICE CORD 09/ERROR CORD 21 [AUDIO]
- DTC: U3003:16, 09:Er20, DEVICE CORD 09/ERROR CORD 20 [AUDIO]
- DTC: 09:Er22 [AUDIO]
- DTC: 21:Er19, DEVICE CORD 21/ERROR CORD 19 [AUDIO]
- Diagnostic Assist Function [Audio]
- Display Inspection (with display only)
- Switch Inspection
- Speaker Inspection
- Radio Reception Condition Inspection
- Antenna Control Condition Inspection
- Audio Amplifier Control Condition Inspection (with display only)
- Dial Inspection (with display only)
- Audio Amplifier Specification Inspection
- Audio Amplifier (With Bose®) Identify Inspection (with display only)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.