Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 597 (GLASS/WINDOWS/MIRRORS)POWER WINDOW MOTOR REMOVAL/INSTALLATION
2010 Mazda 5 Sport, 2.3 L, Standard
Power Window Motor Removal/Installation
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Power Window Motor Removal/Installation
WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
- Half open the door glass.
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] .)
- Disconnect the negative battery cable.
- Remove the following parts:
Front door
- Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
- Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
Sliding door
- Side door garnish (See SIDE DOOR GARNISH REMOVAL/INSTALLATION .)
- Rear side trim (See REAR SIDE TRIM REMOVAL/INSTALLATION .)
- Sliding door trim (See SLIDING DOOR TRIM REMOVAL/INSTALLATION .)
- Remove the bolts.
- Remove the power window motor from the power window regulator drum.
- Disconnect the power window motor connector.
- Install in the reverse order of removal.NOTE:
- When installing the power window motor to the power window regulator drum, the drum housing tabs may detach from the door module. If this happens, insert a hand through the service hole to engage the drum housing tabs, and install the power window motor to the drum while supporting the drum housing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.