SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 546 (INTERIOR TRIM)FRONT DOOR TRIM REMOVAL/INSTALLATION
2010 Mazda 5 Sport, 2.3 L, Standard

Front Door Trim Removal/Installation

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Front Door Trim Removal/Installation
WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] .)
  2. Disconnect the negative battery cable.
  3. Open the cap using a small flathead screwdriver and remove the screw.
  4. Remove the inner handle cover.
  5. Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION .)
    Fig 1: Identifying Inner Handle Cover And Screw
    G05545848Courtesy of MAZDA MOTORS CORP.
  6. Pull up the cover and remove the screw.
  7. Detach clips A from the front door using a fastener remover.
  8. Pull the front door trim upward and detach tabs B from the front door.
  9. Disconnect the power window main switch connector and the power outer mirror switch connector. (Driver's side)
  10. Disconnect the power window subswitch connector. (Passenger's side)
  11. Remove the front door trim.
  12. Install in the reverse order of removal.
    Fig 2: Identifying Front Door Trim
    G05545849Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.