Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISELECTRICALHORNSINFORMATION CENTER [INSTRUMENTATION/DRIVER INFO]INSTRUMENT CLUSTER REMOVAL/INSTALLATION

2010 Mazda 5 Sport, 2.3 L, Standard

Instrument Cluster Removal/Installation

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Instrument Cluster Removal/Installation

CAUTION:

When replacing the instrument cluster, the configuration procedure must be performed before removing the instrument cluster. Replacing the instrument cluster without performing the configuration procedure will result in system malfunction.

Perform the instrument cluster configuration when replacing it. (See INSTRUMENT CLUSTER CONFIGURATION .)
Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] .)
Disconnect the negative battery cable.
Remove the meter hood. (See METER HOOD REMOVAL/INSTALLATION .)
Remove the screw.

Fig 1: Identifying Instrument Cluster Remove/Install Components
Courtesy of MAZDA MOTORS CORP.
Remove the instrument cluster.
Disconnect the connector.
Install in the reverse order of removal.
When replacing the instrument cluster of vehicles with the immobilizer system, perform the following procedure:
- (See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING [KEYLESS ENTRY SYSTEM] .)
  CAUTION:
  - The removed instrument cluster should be placed with the display side up to prevent grease from leaking from the meters.
    
    Fig 2: Identifying Proper Position Of Display
    Courtesy of MAZDA MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.