Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 299 (TROUBLESHOOTING (SECURITY SYSTEM AND LOCKS SYSTEM))
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Section 299 (Troubleshooting (Security System And Locks System))
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Section 299 (Troubleshooting (Security System And Locks System))
WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
- Locks, Latches And Entry Systems
- Symptom Troubleshooting Chart - Power Door Locks/Keyless Entry Remote Transmitter
- Notes
- Pinpoint Test 1: All Door Locks Are Inoperative
- Pinpoint Test 2: All Door Locks Are Inoperative From One Switch
- Pinpoint Test 3: All Door Locks Are Inoperative From A Single Key Cylinder Switch
- Pinpoint Test 4: A Single Door Lock Is Inoperative - Passenger Doors
- Pinpoint Test 5: A Single Door Lock Is Inoperative - Driver Door
- Pinpoint Test 6: The Door Locks Operate Only One Way
- Pinpoint Test 7: The Doors Do Not Lock/Unlock Using The Keyless Entry Remote Transmitter
- Pinpoint Test 8: Remote Keyless Entry Transmitter Out Of Synchronization
- Pinpoint Test 9: The Panic Feature Does Not Operate Correctly - Unlock And Lock Operate Correctly
- Anti-Theft - Passive Anti-Theft System (Pats)
- Symptom Troubleshooting Chart - Anti Theft System
- Notes
- Pinpoint Test 1: Antenna Not Connected
- Pinpoint Test 2: Pats Ignition Key Transponder Signal Is Not Received
- Pinpoint Test 3: Pats Received Incorrect Key-Code From Ignition Key Transponder
- Pinpoint Test 4: Pats Received Invalid Format Of Key-Code From Ignition Key Transponder
- Pinpoint Test 5: Pats Transceiver Module Signal Is Not Received
- Pinpoint Test 6: Anti-Theft Number Of Programmed Keys Is Below Minimum
- Pinpoint Test 7: The Vehicle Does Not Start - The Anti-Theft Led Proves Out Normally
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.