Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 126 (AIR BAG SYSTEM)REMOVAL & INSTALLATIONSAS CONTROL MODULEINSTALLATION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
SAS Control Module: Installation
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Installation
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Ensure that SAS control module is installed with arrow pointing toward front of vehicle. Tighten retaining nuts to specification. See TORQUE SPECIFICATIONS .
- Activate air bag system. See ACTIVATING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. If a NEW SAS control module is being installed, perform SAS control module configuration. After NEW SAS control module is configured, turn ignition switch to ON position, and after 20 seconds, turn to OFF position. Perform system operation check. See SYSTEM OPERATION CHECK .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.