SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM (AJ]DTC P0610 [AJ]DIAGNOSTIC PROCEDURE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Diagnostic procedure

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Diagnostic procedure
DTC P0610 [AJ] DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Perform PCM configuration procedure, then go to the next step.
(See PCM REPLACEMENT [AJ] ).
3 VERIFY TROUBLESHOOTING OF DTC P0610 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear DTC from PCM memory using M-MDS.
  • Perform the KOEO or KOER SELF TEST using the M-MDS.

    (See KOEO/KOER SELF TEST [AJ] ).

  • Is the PENDING CODE same DTC present?
 Yes Replace PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [AJ] ).
No Go to the next step.
4 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE [AJ] ).
No Troubleshooting completed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.