Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE
Section 611 (Security System And Locks System (Keyless Entry System))
WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Power Door Lock System And Keyless Entry System Location Index[Keyless Entry System]
- Theft-Deterrent System Location Index[Keyless Entry System]
- Immobilizer System Location Index[Keyless Entry System]
- Coil Antenna Removal/Installation[Keyless Entry System]
- Immobilizer System Component Replacement/Key Addition And Clearing[Keyless Entry System]
- Foreword
- No.1 Additional Key Registration Procedure (Using Two Valid Keys) Conditions
- No.2 Additional Key Registration Procedure (Using the M-MDS) Conditions
- No.3 Key Replacement Procedure (Clearing Previously Registered Key ID Numbers, Key Re-registration)
- No.4 Changing the Method for Registering Additional Keys
- No.5 Resetting Procedure for the Immobilizer System when Replacing the PCM or Instrument Cluster Conditions
- No.6 Security Access Procedure
- Transmitter Battery Replacement[Keyless Entry System]
- Transmitter Id Code Registration[Keyless Entry System]
- Keyless Control Module Removal/Installation[Keyless Entry System]
- Keyless Control Module Inspection[Keyless Entry System]
- Keyless Receiver Inspection[Keyless Entry System]
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
