2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Keyless Control Module Removal/Installation[Keyless Entry System]

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  2. Remove the side panel. (See SIDE PANEL REMOVAL/INSTALLATION .)
  3. Remove the bolt and nut.
  4. While inclining the keyless control module along the body panel in the direction indicated by the arrow, disengage the bracket tab from the hole in the body panel.
  5. Disconnect the keyless control module connector.
  6. Remove the keyless control module.
    Fig 1: Disengaging Bracket Tab
    G04931341Courtesy of MAZDA MOTORS CORP.
  7. Remove the screw, then remove the bracket.
    NOTE:
    • The screw which fixes the keyless control module and bracket is for a body ground connection. Be sure to secure the screw when installing.
  8. Install in the reverse order of removal.
Fig 2: Removing Bracket & Screw
G04931342Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.