2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

No.1 Additional Key Registration Procedure (Using Two Valid Keys) Conditions: Procedure

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Valid Key And Key For Registration
G04928949Courtesy of MAZDA MOTORS CORP.
  1. Have one key (key 3) ready for registration.
  2. Using key 1, turn the ignition switch to the ON position.
  3. Verify that the security light illuminates for approx. 3 sΒ  and then goes out.
  4. Using key 1, turn the ignition switch to the LOCK position within approx. 4 sΒ  after the security light goes out.
  5. Remove key 1
  6. Repeat Steps 2-5 using key 2.
  7. Repeat Steps 2-5 using key 3.
  8. If additional keys need to be registered, repeat Steps 1-7 in the same manner as key 3.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.