Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Section 30 (Multiplex Communication)
WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
- Multiplex Communication System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Terminals Of Ecu
- Diagnosis System
- DTC Check / Clear
- Diagnostic Trouble Code Chart
- DTC B1205 AFS ECU Communication Stop
- DTC B1211 Driver Door ECU Communication Stop
- DTC B1212 Front Passenger Door ECU Communication Stop
- DTC B1213 Tilt and Telescopic ECU Communication Stop
- DTC B1214 Short to B+ in Door System Communication Bus Malfunction; DTC B1215 Short to GND in Door System Communication Bus Malfunction
- DTC B1247 Tire Pressure Monitor Receiver Communication Stop
- DTC B1248 AVC-LAN Communication Impossible
- DTC B1262 A/C ECU Communication Stop
- DTC B1263 Luggage Room Junction Block ECU Communication Stop
- DTC B1266 Short to B+ in Instrument Panel System Communication Bus Malfunction; DTC B1267 Short to GND in Instrument Panel System Communication Bus Malfunction
- DTC B1269 Theft Deterrent ECU Communication Stop
- DTC B1271 Combination Meter ECU Communication Stop
- DTC B1272 Power Seat ECU Communication Stop
- DTC B1273 Sliding Roof ECU Communication Stop
- DTC B1278 Combination Switch ECU Communication Stop
- DTC B1281 Airbag ECU Communication Stop
- DTC B1282 Skid Control ECU Communication Stop
- DTC B1283 Driver Side Junction Block ECU Communication Stop
- DTC B1284 Passenger Side Junction Block ECU Communication Stop
- DTC B1285 Steering PAD Switch Communication Stop
- DTC B1289 Passenger Seat ECU Communication Stop
- DTC B1291 Short to B+ in Light System Communication Bus Malfunction; DTC B1292 Short to GND in Light System Communication Bus Malfunction
- DTC B1294 Immobiliser ECU Communication Stop
- DTC B1296 Front Light ECU Communication Stop
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
