2008 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

DTC Check / Clear

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC 
    1. Connect the intelligent tester (with CAN VIM) to the DLC3.
    2. Turn the ignition switch ON.
    3. Read DTCs on the tester screen.

      HINT:

      Refer to the intelligent tester operator's manual for further details.

  2. CLEAR DTC 
    1. Connect the intelligent tester to the DLC3.
    2. Turn the ignition switch ON.
    3. Erase the DTCs following the prompts on the tester screen.

      HINT:

      Refer to the intelligent tester operator's manual for further details.

      Fig 1: Connecting Intelligent Tester To DLC3
      G05294423Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.