Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Chart
WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC TROUBLE CODE CHART
| DTC No. | Detection Item | Trouble Area |
|---|---|---|
| B1205 | AFS ECU Communication Stop |
|
| B1211 | Driver Door ECU Communication Stop |
|
| B1212 | Front Passenger Door ECU Communication Stop |
|
| B1213 | Tilt and Telescopic ECU Communication Stop |
|
| B1214 | Short to B+ in Door System Communication Bus Malfunction |
|
| B1215 | Short to GND in Door System Communication Bus Malfunction |
|
| B1247 | Tire Pressure Monitor Receiver Communication Stop |
|
| B1248 | AVC-LAN Communication Impossible |
|
| B1262 | A/C ECU Communication Stop |
|
| B1263 | Luggage Room Junction Block ECU Communication Stop |
|
| B1266 | Short to B+ in Instrument Panel System Communication Bus Malfunction |
|
| B1267 | Short to GND in Instrument Panel System Communication Bus Malfunction |
|
| B1269 | Theft Deterrent ECU Communication Stop |
|
| B1271 | Combination Meter ECU Communication Stop |
|
| B1272 | Power Seat ECU Communication Stop |
|
| B1273 | Sliding Roof ECU Communication Stop |
|
| B1278 | Combination Switch ECU Communication Stop |
|
| B1281 | Airbag ECU Communication Stop |
|
| B1282 | Skid Control ECU Communication Stop |
|
| B1283 | Driver Side Junction Block ECU Communication Stop |
|
| B1284 | Passenger Side Junction Block ECU Communication Stop |
|
| B1285 | Steering PAD Switch Communication Stop |
|
| B1289 | Passenger Seat ECU Communication Stop |
|
| B1291 | Short to B+ in Light System Communication Bus Malfunction |
|
| B1292 | Short to GND in Light System Communication Bus Malfunction |
|
| B1294 | Immobiliser ECU Communication Stop |
|
| B1296 | Front Light ECU Communication Stop |
|
HINT:
|
||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
