Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus IS FFACTORY OEM SERVICE PROCEDURE
Oil Level Sensor: Removal
- REMOVE ENGINE UNDER COVERÂ
- REMOVE NO. 2 ENGINE UNDER COVERÂ
- REMOVE FRONT LOWER SUSPENSION MEMBER PROTECTORÂ (See REMOVAL )
- DRAIN ENGINE OILÂ (See OIL AND OIL FILTERÂ )
- DRAIN AUTOMATIC TRANSMISSION FLUIDÂ (See REMOVAL )
- DISCONNECT OIL COOLER TUBEÂ (See REMOVAL )
- REMOVE CRANK POSITION SENSOR BRACKETÂ
- Using a clip remover, disconnect the harness clamp.
- Remove the bolt and crank position sensor bracket.
- REMOVE ENGINE OIL LEVEL SENSORÂ
- Disconnect the engine oil level sensor connector.
- Remove the 4 bolts.
- Rotate the engine oil level sensor 180° counterclockwise and remove it.
- Cut off the gasket as shown in the illustration.
- Remove the gasket from the oil level sensor.
HINT:
After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
