Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting
The hand-held tester can be used during steps 3, 8 and 11.
- VEHICLE BROUGHT TO WORKSHOP
- (SEE CUSTOMER PROBLEM ANALYSIS CHECK )
- (SEE DTC CHECK/CLEAR )
- PROBLEM SYMPTOM CONFIRMATION
SYMPTOM DOES NOT OCCUR (Go to step 5)
SYMPTOM OCCURS (Go to step 6 )
- SYMPTOM SIMULATION (SEE HOW TO PROCEED WITH TROUBLESHOOTING )
- CHECK MULTIPLEX COMMUNICATION SYSTEM (SEE HOW TO PROCEED WITH TROUBLESHOOTING
)
HINT:
The steering lock ECU is connected to the multiplex communication system. Therefore, be sure to check that there are no problems in the multiplex communication system before performing troubleshooting.
- CHECK CAN COMMUNICATION SYSTEM (SEE HOW TO PROCEED WITH TROUBLESHOOTING
)
HINT:
This ECU is connected to the CAN communication system. Therefore, be sure to check that there are no troubles in the CAN communication system before performing troubleshooting.
- (SEE DTC CHECK/CLEAR
)
DTC IS NOT OUTPUT (Go to step 9)
DTC IS OUTPUT (Go to step 10 )
- (SEE PROBLEM SYMPTOMS TABLE
)
NG: Go to step 11
- (SEE DIAGNOSTIC TROUBLE CODE CHART )
- CIRCUIT INSPECTION (SEE DTC B2775 INTERIOR VERIFICATION ABNORMAL (TO THEFT DETERRENT ECU) to SHIFT LOCK CONTROL ECU COMMUNICATION CIRCUIT )
- PROBLEM IDENTIFICATION
- REPAIR OR REPLACEMENT
- CONFIRMATION TEST
END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
