Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Chart
If a trouble code is displayed during the DTC check, check the circuit listed for that code in the table below.
DIAGNOSTIC TROUBLE CODE CHART
| DTC | Description |
|---|---|
| DTC B2775 | INTERIOR VERIFICATION ABNORMAL (TO THEFT DETERRENT ECU) |
| DTC B2776 | STEERING LOCK MOTOR MALFUNCTION |
| DTC B2777 | +B CIRCUIT MALFUNCTION |
| DTC B2778 | INTERLOCK CABLE MALFUNCTION |
| DTC B2780 | PUSH SWITCH/KEY UNLOCK WARNING SWITCH MALFUNCTION |
| DTC B2799 | ENGINE IMMOBILIZER SYSTEM MALFUNCTION |
HINT:
- DTCs B2793, B2794, B2795, B2796, B2797 and/or B2798 are detected for troubles found when the smart key is inserted into the starter switch.
- DTCs B2793, B2794, B2795, B2796, B2797 and/or B2798 indicate troubles in the steering lock ECU and the transponder key ECU, and the same troubleshooting method is applied to both ECUs. Therefore, if these DTCs are detected, refer to the immobilizer section to conduct troubleshooting (see DIAGNOSTIC TROUBLE CODE CHART ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
