Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Problem Symptoms Table
*1: Check whether or not the key which did not start the engine has been registered and that it is possible to start the engine with other already registered keys.
*2: Finish the automatic registration mode because the mode might be still activated.
*3: The security indicator blinks when the theft deterrent ECU receives a signal through BEAN from the transponder key ECU.
*4: If DTC indicating that the theft deterrent ECU'S communication is cut off in BEAN is detected, repair it first.
*5: COMMUNICATION ID is different between the theft deterrent ECU and the steering lock ECU.
*6: COMMUNICATION ID is different between the steering lock ECU and the ECM.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
