Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
How To Proceed With Troubleshooting
HINT:
- Use following procedures to troubleshoot the power mirror control system.
- The hand-held tester should be used in steps 3. and 5.
- VEHICLE BROUGHT TO WORKSHOP
- Go to next step.
- CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK (See CUSTOMER PROBLEM ANALYSIS CHECK
)
- Go to next step.
- INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)
- Using the hand-held tester to check if the Multiplex Communication System (MPX) is functioning normally.
Result:
RESULTResult Proceed to MPX DTC is not output A MPX DTC is output B
- B: Go to MULTIPLEX COMMUNICATION SYSTEM (See DIAGNOSTIC TROUBLE CODE TABLE )
- A: Go to next step.
- Using the hand-held tester to check if the Multiplex Communication System (MPX) is functioning normally.
- See PROBLEM SYMPTOMS TABLE
Result:
RESULTResult Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B - B: Go to step 7 .
- A: Go to next step.
- OVERALL ANALYSIS AND TROUBLESHOOTING
- See DATA LIST/ACTIVE TEST
- See TERMINALS OF ECU
- See ON-VEHICLE INSPECTION
- See INSPECTION
- Go to next step.
- ADJUST, REPAIR OR REPLACE
- Go to next step.
- CONFIRMATION TEST
- END
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
