2005 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Data List/Active Test

  1. READ DATA LIST 

    HINT:

    Using the hand-held tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

    1. Connect the hand-held tester to the DLC3.
    2. Turn the ignition switch ON.
    3. Read the DATA LIST.

      Multiplex network door ECU front LH (driver door ECU): 

      MULTIPLEX NETWORK DOOR ECU FRONT LH (DRIVER DOOR ECU)

      Item Measurement Item/ Range (Display) Normal Condition Diagnostic Note
      MIRPOSSEN V Vertical mirror position/ Min.: 0, Max.: 5 V Within range from 0 to 5 V -
      MIRPOSSEN H Horizontal mirror position/ Min.:0, Max.: 5 V Within range from 0 to 5 V -

      Multiplex network door ECU front RH (passenger door ECU): 

      MULTIPLEX NETWORK DOOR ECU FRONT RH (PASSENGER DOOR ECU)

      Item Measurement Item/ Range (Display) Normal Condition Diagnostic Note
      MIRPOSSEN V Vertical mirror position/ Min.:0, Max.: 5 V Within range from 0 to 5 V -
      MIRPOSSEN H Horizontal mirror position/ Min.:0, Max.: 5 V Within range from 0 to 5 V -

      Driver side J/B ECU: 

      Fig 1: Driver Side J/B ECU Data List
      G02956680Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Position control ECU assy (driver side): 

      Fig 2: Position Control ECU Assy Data List (Driver Side - 1 Of 2)
      G02956681Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.