Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Land Rover Freelander SFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System
- 70.25.02 Brake bleed
- 70.35.10 Cable - handbrake - check and adjust
- 70.12.03 Drum - rear
- 70.12.10 Disc - front
- 70.15.02 Hose - front - primary - LH
- 70.15.17 Hose - rear
- 70.30.08 Cylinder - master - tandem - LHD
- 70.30.08 Cylinder - master - tandem - RHD
- 70.35.08 Lever assembly - handbrake
- 70.35.25 Cable - handbrake
- 70.35.40 Switch - handbrake warning
- 70.35.42 Switch - stop light
- 70.35.44 Sensor - brake pedal position
- 70.40.02 Brake pads - front - set
- 70.40.09 Brake Shoes - Rear Set
- 70.50.01 Servo assembly - LHD
- 70.50.01 Servo assembly - RHD
- 70.50.19 Vacuum pump - Td4 - manual
- 70.50.19 Vacuum pump - Td4 - automatic
- 70.50.20 Vacuum - enhancer - KV6
- 70.55.28 Carrier assembly - caliper - front
- 70.60.19 Wheel cylinder - rear
- 70.65.01 ABS Electronic control unit (ECU) - Td4 Models
- 70.65.01 ABS Electronic control unit (ECU) - K1.8 Models
- 70.65.01 ABS Electronic control unit (ECU) - KV6 Models
- 70.65.06 Switch - low fluid level
- 70.65.29 Sensor & harness - front wheel - RH
- 70.65.30 Sensor & harness - front wheel - LH
- 70.65.31 Sensor & harness - rear wheel
- 70.65.49 Modulator unit
- 70.70.11 Switch - hill descent - from 04MY
- 70.70.13 Switch - hill descent - up to 03MY
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
