2003 Land Rover Freelander SFACTORY OEM SERVICE PROCEDURE

70.65.49 Modulator unit: Refit

  1. Position modulator to mounting bracket fit bolts and tighten to 9 Nm (7 lbf.ft).
  2. Clean brake pipe unions.
  3. Connect brake pipe unions to modulator ensuring pipes are connected to their correct ports.
  4. Tighten unions to 17 Nm (12 lbf.ft).
  5. Connect ABS modulator multiplug and secure catch.
  6. Td4 and KV6 models: Position air intake duct to body.
  7. Td4 and KV6 models: Secure intake duct to washer bottle filler neck and harness clip.
  8. Td4 and KV6 models: Fit air intake hose.
  9. Fit PAS reservoir to mounting bracket.
  10. Fit bolts securing PAS oil cooler pipes and tighten to 10 Nm (7.5 lbf.ft).
  11. Td4 models:Β  Fit intercooler outlet hose and tighten clips.
  12. Td4 and KV6 models:Β  Fit engine acoustic cover if fitted.

    Refer to INSTALLATION .

  13. Bleed brakes.

    Refer to BRAKE BLEEDΒ .

  14. To ensure correct operation, the ABS system MUST be tested using T4.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.