2003 Land Rover Freelander SFACTORY OEM SERVICE PROCEDURE

70.65.49 Modulator unit: Remove

  1. Td4 and KV6 models: Remove engine acoustic cover if fitted.

    Refer to REMOVAL .

    Fig 1: Releasing Clip Securing Harness And Intake Duct To Body
    G03469694Courtesy of LAND ROVER NORTH AMERICA, INC.
  2. Td4 and KV6 models:Β  Release and remove air intake hose.
  3. Td4 and KV6 models:Β  Release clip securing harness and intake duct to body.
  4. Td4 and KV6 models:Β  Lift duct from body, release clip from washer reservoir filler hose.
  5. Td4 and KV6 models:Β  Release and remove air intake duct.
    Fig 2: Removing Intercooler Outlet Hose
    G03469695Courtesy of LAND ROVER NORTH AMERICA, INC.
  6. Td4 models:Β  Loosen 2 clips and remove intercooler outlet hose.
    Fig 3: Removing 2 Bolts Securing PAS Oil Cooler Pipes
    G03469696Courtesy of LAND ROVER NORTH AMERICA, INC.
  7. Remove 2 bolts securing PAS oil cooler pipes.
  8. Release PAS reservoir from mounting bracket and position aside.
    Fig 4: Disconnecting ABS Modulator Multiplug
    G03469697Courtesy of LAND ROVER NORTH AMERICA, INC.
  9. Release catch and disconnect ABS modulator multiplug.
  10. Position cloth under modulator to absorb fluid spillage.
    CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove fluid and clean area with water.
  11. Disconnect 2 inlet brake pipes unions from ABS modulator.
  12. Disconnect 4 outlet brake pipes unions from ABS modulator.
    CAUTION: Always fit plugs to open connections to prevent contamination.
  13. Remove 3 bolts securing ABS modulator to mounting bracket.
  14. Release and remove ABS modulator from mounting bracket.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.