SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2024NIRO EXREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASADVANCED DRIVER ASSISTANCE SYSTEM PARKING DIAGNOSIS (HEV) (2 OF 2)DTC C1659-87: CAN TIME-OUT SASDTC INFORMATIONDTC DETECTING CONDITION
2024 Kia Niro EX

DTC Information: DTC Detecting Condition

2024 Kia Niro EXSECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy
  • CAN signal monitoring
  • Poor connection connector
  • Abnormal CAN communication circuits (open circuit, short circuit)
    • CAN high line open circuit
    • CAN low line open circuit
    • CAN high and low line open circuit
    • CAN high line short circuit to power/ground
    • CAN low line short circuit to power/ground
    • CAN high, low lines shorted to each other
  • Short circuit to ground after CAN high, low lines
  • Poor termination resistance
  • Transmitting controller bus off
  • Transmitting controller disconnected
  • Transmitting controller power, fuse or ground fault
  • Transmitting controller H/W, S/W fault
  • CAN line noise
  • Faulty MDPS
Enable Condition
  • Ignition "ON"
  • No CAN bus off
  • No C181287
  • Normal 12V battery voltage (8.5 to 16.5V)
Threshold Value
  • SAS CAN message is not received
Diagnosis Time
  • 0.5s
Clear Time
  • Immediately
Symptom
  • ADAS_PRK disabled
Disable Condition
  • Normal SAS CAN signal received
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.