Basic Inspection: Notes

2024 Kia Niro EXSECTION Notes
WARNING: HEV battery system uses high voltage.
It may cause death or damage due to electrical shock, if you do not follow below Instructions.
  • Follows instructions of service information.
  • Wear and use insulated gloves and tools.
  • Ignition "OFF", disconnect 12V battery (+) connector, Open lower-voltage junction block cover which is in engine room and wait 5 minutes after disconnect A/S interlock. Watch the short between disconnected connector and chassis)
  • Check high voltage terminal on power relay assembly is lower than 30V.
  • Be careful that it should not be short between terminals when measuring battery cell voltage. You may be injured due to spark, parts damage or electrical shock.
  • Metallic material cause high voltage short that may cause damage of life or vehicle. Therefore, get rid of all the metallic material before working, (metallic material: watch, ring, any metallic products etc.)
  • After disconnect high voltage cable, be careful not to happen short between exposed terminals on high voltage connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.