Circuit Inspection

2020 Kia Soul LX, Standard TransSECTION Circuit Inspection
G13285848Courtesy of KIA MOTORS AMERICA, INC.
Charging System Inspection
Inspection Condition (+) Probe (-) Probe Specification
connector Terminal connector Terminal
  1. Ignition "ON".
  2. Start the engine and turn the headlight, rear window defogger and all other electrical devices.
  3. Measure voltage between (+) terminal and (-) terminal of battery while maintaining engine RPM at 2500RPM.
Battery (+) Terminal Battery (-) Terminal 11.5 to 14.5V
ESC Circuit Inspection
Inspection Condition (+) Probe (-) Probe Specification
connector Terminal connector Terminal
  1. Disconnect the electrical connector(s) from the concerned component.
  2. Ignition "ON".
ESC connector 1, 25, 29 (power) Chassis ground - B+
ESC connector 13, 38 (ground) Chassis ground - Approx. below 1Ω

Good 

No Good 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.